Fast Setting Water Stop Repair Mortar
Description
AD-TEK PLUG is a one-component, rapid hardening plug composition for permanent stopping of water seepage and pressure leaks through cracks and construction joints in concrete, rock, wooden, and masonry structures.
AD-TEK PLUG is a chloride-free, ready-to-use grey powder based on Portland cement with special additives.
Uses
AD-TEK PLUG can be used for vertical, horizontal, and overhead applications stopping water from static cracks and holes in:
- Water storage tanks
- Basements
- Building foundations
- Retaining walls
- Sewers
- Below ground car parks
- Mines
Benefits
- Mixed just with water or can be used as a dry powder
- Stops water flow
- Fast setting with rapid strength development
- Permanent durable repair
- Can be installed underwater
- High water-stopping power and hydraulic resistance
- Good adhesion to repaired material
- Non-toxic
- Easy application
Properties
Property | Value |
---|---|
Appearance | Cementitious grey powder |
Grain Size | Max 1.0 mm |
Bulk density | Approx. 1.3 g/cm3 |
Initial setting time | 30 seconds (after mix) |
Temperature for application | From 5 to 40 deg Celsius |
Compressive strength (MPa) |
|
Flexural strength (MPa) | 28 days: 7.7 |
Bond strength (MPa) | 28 days: 6.8 |
Instructions for Use
AD-TEK PLUG can be dry applied as a powder or applied by hand as a putty consistency after mixing with water by spatula:
- The repaired materials must be cleaned of oily substances, dust and dirt.
- Thoroughly and quickly mix the powder and water for no more than 60 seconds in approx. mass ratio of 3 to 1. Some heat will be released.
- Mix only the quantity that can be immediately applied by gloved hand or trowel.
- Quickly place the mixed mortar firmly into the leaking voids and hold in place with a gloved hand or trowel until the mortar is sufficiently hard to remain in place.
- When the leak is completely stopped, a 2-3 mm layer of AD-TEK R can be applied over the AD-TEK Plug mortar.
- If the water pressure is very high and dislodges the applied mortar, use a timber plug or similar which can then be covered and secured with AD-TEK Plug mortar.
- All tools must be cleaned with water after use. Hardened AD-TEK Plug can only be removed mechanically.
Handling Precautions
- Protective gloves and clothing are recommended.
- Avoid contact with the skin.
- The Material Safety Data Sheet is available on request.
Packaging, Shelf Life and Storage
AD-TEK PLUG is available in 5 or 15 kg plastic pails.
AD-TEK PLUG has a shelf life of 12 months if kept in a dry store in sealed plastic pails.
Please contact our technical department for further information.
Disclaimer: Any advice, recommendation, information, assistance or service provided by application is in good faith and is believed by AD-TEK PTY LTD to be appropriate and reliable. However, any advice, recommendation, information, assistance or service provided by AD-TEK PTY LTD is provided without liability.